If scanning fails, complete section 3 (page 9). Scan to the desired Sharpdesk destination. 5Ħ Section 2 If the Known Scanners field is NOT blank or grayed out (see page 7) skip to section 3. Click Apply Send a test scan to the desired Sharpdesk destination.
Click Apply 4 Continued on next pageĥ Re-Adding A Sharpdesk User Profile From The Sharp Imager Recheck the box Verify this pop up completes successfully. The Sharpdesk Network Scanner Tool will temporarily remove your profile (with the old incorrect IP address) and re-add your profile (with the new current IP address) Uncheck the profile Verify this pop up completes successfully.
Sharpdesk 3.2 user manual windows 7#
Windows XP Windows 7 A A Double-click the NST 1b Click here Double-click the NST 1a 1b 1a Click here 3 Continued on next pageĤ Remove and re-add your Sharpdesk user profile from the Sharp imager Note: The most common reason for receiving the error message is that the IP address on your workstation has most likely changed (DCHP). Note: If the NST icon looks like this, right-click it > Start (or reboot the PC). If this icon is NOT present on the system tray do the following: Click Start > Programs (or All Programs) > Sharpdesk > Network Scanner Tool. Double-click the NST icon (see proper image below) and follow the steps on page 4-5. 2ģ Confirm that the Network Scanner Tool is present & initialized If you receive a CE-02 error, Can t Find Selected Server, or Selected Servers Not Found message on the Sharp Scanner do the following: 1a. If scanning fails, complete section 2 (page 6). 1 Use this guide if you are no longer able to scan to Sharpdesk Instructions: Begin with section 1 (easiest) and complete all sections only if necessary.